AEB-L and ebony drop point

leifjl

leifjl

Feedback: +18 / =0 / -0
Joined
Nov 27, 2011
Messages
789
Full height flat grind with a thin edge (.010") for slicing, and the tang's been tapered down to .045" for weight reduction and balance.

7.5" tip to butt with 3.25" of usable cutting edge.

Double cryo'ed and triple tempered to 60 HRC.

low maintenance, non reflective bead blasted finish on the blade with Gaboon ebony and carbon fiber pins.

185$ shipped and insured.



















Thanks for looking!

Leif Lambertson
 
Very nice. I have been reading about AEB-L, and it's ability to acheive an extremely sharp edge for stainless. I am guessing this one is very "Slicey" :)
 
You must log in or register to reply here.
Back
Top