- Joined
- Dec 21, 2006
- Messages
- 3,158
Up next is a simple paring knife from AEB-L stainless steel, dressed in Claro Walnut. The wood was sealed with quite a few coats of Watco Danish Oil, with a glossy Tru-Oil finish. If you prefer a satin finish, just let me know and I'll knock off that gloss for ya. This little guy will be your go-to knife for most chores!
SOLD shipped to the lower 48 states. If you live elsewhere, just let me know and we'll get something put together as far as shipping goes. Thanks so much for your interest!
Paypal: samuraistuart@yahoo.com
Facebook: Stuart Davenport Knives
AEB-L stainless steel @ 62HRC (Peter's Heat Treating)
.063" stock, tapered to point, FFG, flexes just slightly at the tip, just barely.
Edge was .003" or thereabouts before sharpening, just reflected light, 15° per side.
Final polish at 8k (JIS)
OAL: 8 7/16"
Blade: 4 1/8"
Edge: 3 1/2"
Handle: 4 5/16"
.063" stock, tapered to point, FFG, flexes just slightly at the tip, just barely.
Edge was .003" or thereabouts before sharpening, just reflected light, 15° per side.
Final polish at 8k (JIS)
OAL: 8 7/16"
Blade: 4 1/8"
Edge: 3 1/2"
Handle: 4 5/16"




SOLD shipped to the lower 48 states. If you live elsewhere, just let me know and we'll get something put together as far as shipping goes. Thanks so much for your interest!
Paypal: samuraistuart@yahoo.com
Facebook: Stuart Davenport Knives
Last edited: