(All sold) DCL Knives-3 Humpbacks in aeb-l and Canvas

DCL Knives

DCL Knives

Feedback: +41 / =0 / -0
Joined
Jun 6, 2012
Messages
783
Hey again guys, I've been busy working on getting my next batch ready for heat treat, finally got those sent off so now I get to finish some :D

These 3 are one from my batch of water jet blades. This is definitely my favorite design of the group and I've decided to call it the "humpback" for now, because I couldn't really think of anything better :o

Your choice of any of them for $145 now $130 shipped inside the US.

Specs are all pretty much the same so I'll just list them once:
OAL-6 7/15"
Blade Length-2 5/8"
Steel- 1/8" aeb-l heat treated professionally by Peters to 60 hrc
Handle materiel-Slim green canvas micarta secured with 2 g10 tubes
Holstex sheath spaced for a large tek-lok

#1







#2 (sorry about the kydex dust in front of the scales)







#3 (this one has a lighter makers mark then the others, it's still there, just not as visible)






Thanks for looking, please let me know what you think
Drew
 
Last edited:
Thanks for the comment dingle and Chris, it's appreciated!

Moander, email replied. It's yours, thanks.
 
Very nice! Still getting back on my feet job-wise, but you're at the top of my list when I get there. Great to see you're still doing wonderful things, even more impressive than the last batch even. I've always loved this pattern and aeb-l (thanks to other knives you've made I own), but the new 3D contours of that handle and swedged blade on these ones really frost the cake. Keep it up.
 
Very very nice Drew:thumbup:

Hummmm, need or want...I'm really leaning towards NEED:D

I'll see how long my will power lasts:o
 
The grinds are very clean and I like the palm swells. I bet you can get a good grip on any of those knives.
 
You must log in or register to reply here.
Back
Top