- Joined
- Feb 15, 2014
- Messages
- 632
Hi there folks. I have got a few traditionals to sell. I cannot open these particular ones anymore because of hand strength and dexterity issues. Some of them have been sharpened on my wicked edge, some of them are like new.
.FS Northwoods Hawthorne Jack in stag, clip point .
This knife has been sharpened. I copied the factory bevels with my wicked edge. You will likely be able to see in the picture of the blade centering thatt at the very tip of this blade the width of the secondary bevel is different from one side to the other. Other than that it is quite good. I would say it's about a 7 pull.
I am asking $140 USD shipped anywhere in the continental US or Canada
Upnext is a GEC Viper in Northfield trim but with the satin blade. This is in smooth oiled bone. This was an SFO from collector knives. It has never been sharpened it is like new in tube. I would say that this one is a seven and a half or maybe even eight pull.
I am asking $140 USD SOLDhipped anywhere in the US or Canada
Up next is a tGEC #98 split back whittler in Tidiute trim. This one has been sharpened on my wicked edge to copy what angles were already there from the factory. This one is mechanically awesome. The 5 inch split back is an amazing feat in itself. There is no blade rub . There are a couple tiny little spots on the main blade just because this is carbon steel and that's what happens. Hahaha. I would say the spring strength on all three of these blades is hovering around 7.
I am also asking $140 USD SOLDfor this shipped anywhere in the US or Canada.
You can say I'll take it here but then please email me or send me a PM. I may be out to lunch on my prices so feel free to make me an offer. I have never sold any of my slip joints before this.
Thank you very much for looking.
.FS Northwoods Hawthorne Jack in stag, clip point .
This knife has been sharpened. I copied the factory bevels with my wicked edge. You will likely be able to see in the picture of the blade centering thatt at the very tip of this blade the width of the secondary bevel is different from one side to the other. Other than that it is quite good. I would say it's about a 7 pull.
I am asking $140 USD shipped anywhere in the continental US or Canada
Upnext is a GEC Viper in Northfield trim but with the satin blade. This is in smooth oiled bone. This was an SFO from collector knives. It has never been sharpened it is like new in tube. I would say that this one is a seven and a half or maybe even eight pull.
I am asking $140 USD SOLDhipped anywhere in the US or Canada
Up next is a tGEC #98 split back whittler in Tidiute trim. This one has been sharpened on my wicked edge to copy what angles were already there from the factory. This one is mechanically awesome. The 5 inch split back is an amazing feat in itself. There is no blade rub . There are a couple tiny little spots on the main blade just because this is carbon steel and that's what happens. Hahaha. I would say the spring strength on all three of these blades is hovering around 7.
I am also asking $140 USD SOLDfor this shipped anywhere in the US or Canada.
You can say I'll take it here but then please email me or send me a PM. I may be out to lunch on my prices so feel free to make me an offer. I have never sold any of my slip joints before this.
Thank you very much for looking.
Last edited:
