another question on bandsaws

[Keith Willis]

Again,i have been making knives for just a few months,using stock removal,but i have not learned the proper method of heat treating.I work in a sawmill and have access to several bandsaw blades.Some are.100 thick the others are about.060,not that it matters, the thickness that is,i was wondering if someone could give me some advice on the treating process,or maybe there is a website.
Thanks,

 

[bikermikearchery]

look at the sticky at the top of the page titled "for the newbie maker starting out as well as the seasoned maker"
You'll fimd this http://www.knivesby.com/knifemaking.html
And a lot more.

 

[SteelSlaver]

And it is likely that the band saw blades are 15n20 or L6. Either of which is fine steel. Trouble is the word likely.

 

[Keith Willis]

Thanks for the help,i am going to contact the manufacture and find out.