Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,193
Good afternoon folks , I have this newly finished B & T's to offer .
It has a full height flat grind with a hand sanded finish . It was ground from 7/64 A-2 tool steel bar stock and heat treated to an Rc. 61-62 with the sub-zero quench .
The overall length is 8-1/4 with the blade at 3-1/2 , 5/8 wide and a sharpened edge at 3"
The sheath is ambidextrous carry .
Handled in Coyote Brown Tero-tuf with green liners and brass Corby bolts .
$135.00 , shipping included in the USA, Pay-pal , postal M/O or check held to clear .
My PP is sandlot@charter.net .
Hope you all like it and comments are always welcome and apprecia
It has a full height flat grind with a hand sanded finish . It was ground from 7/64 A-2 tool steel bar stock and heat treated to an Rc. 61-62 with the sub-zero quench .
The overall length is 8-1/4 with the blade at 3-1/2 , 5/8 wide and a sharpened edge at 3"
The sheath is ambidextrous carry .
Handled in Coyote Brown Tero-tuf with green liners and brass Corby bolts .
$135.00 , shipping included in the USA, Pay-pal , postal M/O or check held to clear .
My PP is sandlot@charter.net .
Hope you all like it and comments are always welcome and apprecia
Last edited:
