Belt Grinders

I was thinking longboard wheels. They are 2 inches wide, good rubber, bearings are cheap to replace and they last a long time. And they should slide in the drive shaft of the motor. What do you guys think?
 
Whatever wheels you use, just make sure the bearings are rated for speeds that your belt will be moving at.
 
From my research, Coote makes a nice 2x72 belt grinder. It doesn't have all the fancy attachments that can be used on a KMG; but people seem to like them.

I'll be getting a Coote within the next two months, hopefully.
 
Oops! I accidentally posted this to "Reply" rather than "New Thread" and now I can't figure out out to get rid of it....sorry!
 
I,m going with a Coote myself,when i can get the money togther.


WULFS where in FL. are you ? Im in Melbourne
 
You must log in or register to reply here.
Back
Top