Benchmade Stryker 910

[Shawn B.]

I have a late nineties Elishewitz Stryker.Can somebody tell me what type of steel the blade is made out of ? I've lost track of where I put the box and paperwork so any help in this matter in this matter would be much appreciated

 

[Wunderbar]

The first ones were ATS-34 and then later Benchmade switched to 154CM.

 

[GarageBoy]

It should say on the back side BTW

 

[elmora2]

As GarageBoy stated, it should say on the blade what the steel is. However, before some certain point, Benchmade didn't seem to label blade steel. So if your blade is early enough not to have the steel marked on the blade, then it would be ATS-34.

 

[Chadilac]

If it is a coated blade it could be M2, but this would be on the blade--910HS

 

[Tiny86]

If there is no marking it is most likely ATS-34.

 

[Nick Hyle]

910HS (or 910HSSR) is the model number. That's what the sticker on the box would say. The blade steel would be marked as M2HS.

 

[chugokujin]

My coated versions said M2 and ATS-34. Yes, it should be on the blade.

 

[Shawn B.]

This thread is closed.