- Joined
- Oct 26, 2005
- Messages
- 17,124
Just in , from Oklahoma maker,Knifemaker's Guild member,Bill Kennedy Jr. , a beautiful EDC slipjoint. This knife,very unique,has one piece milled bolster,liner & cap of 7075 aircraft aluminum,making it light as a feather & very strong.
Black twill G-10, stunning in looks,ss pins. Blade is hollow ground 154 cm ss,59Rc,satin finish. This knife is thin & light,has a sunk joint closed,fantastic EDC set up. The action is glass smooth,medium firm snappy walk "n" talk.
Fit & finish,walk 'n' talk on this knife is outstanding.
Size is 3.5" closed,6" open
Blade is 2.5" with 2-3/8" cutting edge
Knife is numbered on the spring,inside the trough.
Tang is stamped with makers mark on one side & year of build on the opposite.
Ships with a velvet case & makers card with info.
Take a look at this really good looking knife,this is as good as it gets here ....
************Now Sold**************
Black twill G-10, stunning in looks,ss pins. Blade is hollow ground 154 cm ss,59Rc,satin finish. This knife is thin & light,has a sunk joint closed,fantastic EDC set up. The action is glass smooth,medium firm snappy walk "n" talk.
Fit & finish,walk 'n' talk on this knife is outstanding.
Size is 3.5" closed,6" open
Blade is 2.5" with 2-3/8" cutting edge
Knife is numbered on the spring,inside the trough.
Tang is stamped with makers mark on one side & year of build on the opposite.
Ships with a velvet case & makers card with info.
Take a look at this really good looking knife,this is as good as it gets here ....
************Now Sold**************
Last edited: