BIRD AND TROUT SOLD

[G L Drew]

I ordered the wrong thickness of Micarta and had to recover my error by spacing it with some black carbon fiber. This is difficult to see in my photos but look at the last picture to see the layup. The handle should not delaminate with the amount of pins and quality epoxy that I used however all my knives carry a lifetime guarantee (my lifetime, not yours) and if this handle fails I will replace it or refund your money.

This is a stock removal knife from 1/8 inch 52100
Heat treated in my Evenheat furnace to Rc 58-60 with attention to a fine grain throughout the blade
Flat grind with a slight convex
The handle is Micara with a carbon fiber spacer
OveRall length: 9 inches
Blade: 4 1/2 inches
Leather scabbard with a belt loop for a right hand carry

SOLD delivered within the US. My PayPal and email address is gldrewknives@gmail.com

IMG_4794 by Gerald Drew, on FlickrIMG_4795 by Gerald Drew, on FlickrIMG_4796 by Gerald Drew, on FlickrIMG_4797 by Gerald Drew, on FlickrIMG_4799 by Gerald Drew, on FlickrIMG_4801 by Gerald Drew, on Flickr
IMG_4800 by Gerald Drew, on Flickr

 

[redsquid2]

It ended up beautiful!

 

[captjlw]

Hey man, this is just what I've been looking for. I'll take it.