Bird & Trout in Bone Micarta -SOLD

Jack O'Neill

Jack O'Neill

Gold Member
Feedback: +177 / =0 / -0
Joined
Nov 15, 2007
Messages
7,193
Good afternoon folks ,I have this sweet little B&T to offer
It has a full height flat grind from 1/8" A-2 Tool Steel , Satin Finished and heat treated to an Rc 61-62 with the sub-zero quench.

O.A.L is 8" , the blade is at 3-1/4" and 1/2" wide at the plunge . The sharpened edge is at 2-7/8" semi-rounded spine .
Handled in some Bone micarta , reminds me more of the butterscotch micarta we use to get , copper corby bolts and red G-10 liners
Sheath is right hand carry .
SOLD

$140.00 NOW $125.00 with free shipping in the USA , International friends write me for ship cost .
Pay-pal , postal m/o or check(held to clear ) My PP is sandlot@charter.net

Thank you all for viewing my offerings and comments are always welcome
Jack O'Neill

IMG_5792 (4).JPG IMG_5794 (2).JPG IMG_5796 (2).JPG IMG_5799 (2).JPG IMG_5800 (2).JPG
 
Last edited:
I have always liked the thin pattern of a B&T, but just for small tasks or jobs, handy and light, although I do not hunt or fish. a stainless version would be cool, like ATS34, 154cm or AEBL? What are your thoughts Jack? Have you used any of theses steels for stainless or others? There is also just something about the ivory micarta, especsilly some old stuff, looks cool.
 
well my friends I guess it may be time to do so . I have a stick of 154cm just the right size for this pattern . I have a few others to finish 1st then I will get on it .
 
You must log in or register to reply here.
Back
Top