Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,176
Hello all , I recently finished this nice little B & T , so it is time to offer up for your consideration . Hope you all like it .







It is hollow ground from 1/8" A-2 Tools steel , heat treated to Rc.61-62
The blade has a very fine scotch-brite belt satin finish
The O.A.L is 7-1/2" , blade tip to handle is 3-1/2" with a 3-1/4" cutting edge and 7/8" wide .
Handled in Tan Linen Micarta , with yellow liners , brass Corby bolts with a s.s./brass center mosaic pin .
weighs 2.9 oz.
Sheath is right hand carry .
SOLD
$145.00 with free shipping in the USA , international shipping write for cost . Pay-pal ,postal m/o or check held to clear .
My pp is sandlot@charter .
Thanks for looking and comments are always welcome .







It is hollow ground from 1/8" A-2 Tools steel , heat treated to Rc.61-62
The blade has a very fine scotch-brite belt satin finish
The O.A.L is 7-1/2" , blade tip to handle is 3-1/2" with a 3-1/4" cutting edge and 7/8" wide .
Handled in Tan Linen Micarta , with yellow liners , brass Corby bolts with a s.s./brass center mosaic pin .
weighs 2.9 oz.
Sheath is right hand carry .
SOLD
$145.00 with free shipping in the USA , international shipping write for cost . Pay-pal ,postal m/o or check held to clear .
My pp is sandlot@charter .
Thanks for looking and comments are always welcome .
Last edited: