Black G-10 and Locust Wood Liner lock

wwells20

wwells20

Feedback: +15 / =0 / -0
Joined
Dec 31, 2004
Messages
1,907
Blade: 3 1/8" CPM154 flat ground to .015 behind the edge (measured mid blade), .125 at the spine, with distal taper. Heat treated to HRC 60/61 by Peters' of PA. Dual thumb studs, rides on phosper bronse washers. Nice smooth action.


Handle: 4" Black G-10 milled for Black Locust inlay. .040 TI liners with Hourglass standoffs. 3/16" pivot with good detent. Drilled/tapped for right hand tip up carry. All stainless hardware.


Clip: fold over, low ride, stainless. Knife weight: 2.70 oz.










asking $225.00 shipped CONUS with 100% satisfaction or money back.

Paypal preferred (wwells63@aol.com) or USPS money order, or check if you wish.

Thanks for looking, Walter.
 
Very nice looking knife. The wood and G-10 fit so well together. I love the FFG blade, looks like it would take a killer edge and slice through anything in its way. The pocket clip is also a nice deep carry. Just overall a well put together design. Awesome simple knife design that is just beautiful.
 
​
wow, that's spectacular! That inlay is just perfect! I wish I had the monau to buy that knife, but more so the skill to build such a nice knife!
 
You must log in or register to reply here.
Back
Top