Black on Black Forged Chopper *SOLD*

DanitzKnives

DanitzKnives

Knifemaker / Craftsman / Service Provider
Feedback: +16 / =0 / -0
Joined
Jun 26, 2022
Messages
252
Hello again, Today I have a forged chopper to offer. The blade is made from 80CRV2 and features a recurve, forged fuller, false raised clip, flat to convex ground bevel, and a forge texture plus cold bluing finish. The blade was heat treated by me in my knife kiln. This knife comes with a knife case from ace cases (no sheath)

Price = SOLD shipped

Overall Length: 16"
Blade Length: 10 3/4"
Handle Length: 5 1/2" (measured from top)
Thickness: 1/4" (at thickest point)
Blade Steel: 80CRV2
Handle Material: Black Micarta
Pin Material: Black 1/8" G10

IMG_5351.JPG
IMG_5352.JPG
IMG_5353.JPG
IMG_5354.JPG
IMG_5355.JPG
IMG_5356.JPG
 
Last edited:
DanitzKnives said:
Hello again, Today I have a forged chopper to offer. The blade is made from 80CRV2 and features a recurve, forged fuller, false raised clip, flat to convex ground bevel, and a forge texture plus cold bluing finish. The blade was heat treated by me in my knife kiln. This knife comes with a knife case from ace cases (no sheath)

Price = $265 shipped

Overall Length: 16"
Blade Length: 10 3/4"
Handle Length: 5 1/2" (measured from top)
Thickness: 1/4" (at thickest point)
Blade Steel: 80CRV2
Handle Material: Black Micarta
Pin Material: Black 1/8" G10

View attachment 2148874
View attachment 2148875
View attachment 2148876
View attachment 2148877
View attachment 2148878
View attachment 2148880
Click to expand...

What is your targeted hardness with your heat treat???? Do you test them or Have you tested the HRC???
Just curious....
 
jfk1110 said:
What is your targeted hardness with your heat treat???? Do you test them or Have you tested the HRC???
Just curious....
Click to expand...
The target is 60HRC. I don't have a hardness tester to confirm though, which is why I don't include hardness in my posts. Instead I test each knife by chopping, inspecting the edge, re-sharpening if there's any chipping or rolling from decarb, and then chopping some more.
 
DanitzKnives said:
The target is 60HRC. I don't have a hardness tester to confirm though, which is why I don't include hardness in my posts. Instead I test each knife by chopping, inspecting the edge, re-sharpening if there's any chipping or rolling from decarb, and then chopping some more.
Click to expand...


Nice!!! Thanks for filling me in on your process and testing!!👍👍
 
I'd like to see this blade up close and in hand...
I'll take it!
Send me an email with payment info - zalfmonatyahoo
 
You must log in or register to reply here.
Back
Top