Blade: 3" Tanto (3 1/4" cutting edge). Flat ground with convex/"spanto" tip from 1/8" stock, A-2 tool steel heat treated by Peters' of PA to 61/62 HRC, with -300 deg. cryo quench.
Handle: 4" Peel-ply (has a fine texture with plenty of grip but not a pocket shredder) G-10, 1/8" stock, open back/stand off design. All hardware stainless.
Clip: Low ride, set up for right hand, tip up carry but I can set it up for left hand if needed. Knife weighs 2.35 oz.
Asking $((SOLD)) Shipped CONUS with 100% money back if not satisfied.
Paypal preferred, wwells63@aol.com or USPS money order.
"I'll take it" will get it. Thanks for taking a look, Walter.
Handle: 4" Peel-ply (has a fine texture with plenty of grip but not a pocket shredder) G-10, 1/8" stock, open back/stand off design. All hardware stainless.
Clip: Low ride, set up for right hand, tip up carry but I can set it up for left hand if needed. Knife weighs 2.35 oz.
Asking $((SOLD)) Shipped CONUS with 100% money back if not satisfied.
Paypal preferred, wwells63@aol.com or USPS money order.
"I'll take it" will get it. Thanks for taking a look, Walter.
Last edited:
