This knife is part of my "ES-N-TL" line. The difference between this and a full custom Esnyx is that the blade and spring were water jet cut as part of a batch order, and the heat treatment was outsourced to Peters' Heat Treat. The pattern is my design, and was cut to spec on a prototype I sent for them to copy. Besides that, the rest of the knife is fully hand-made, and is the same quality as one of my custom pieces. I placed this order to be able to sell these knives at a more affordable cost than my full customs.
ES-N-TL Swell End Jack
Blade and Spring: CPM 154
Blade Hardness: 61 HRC
Closed Length: 3.5"
Handle Material: Bue Box Elder Burl
Liners and Bolsters: Stainless Steel
Pull: 5
Double Pinned Shield
Mill Relieved Liners
Flush in all 3 positions
Belt finish on the blade
$375 SOLD
*Satisfaction guaranteed. If you are not 100% satisfied with my work, contact me and I will be more than happy to work something out with you.
Questions and opinions are welcome!
ES-N-TL Swell End Jack
Blade and Spring: CPM 154
Blade Hardness: 61 HRC
Closed Length: 3.5"
Handle Material: Bue Box Elder Burl
Liners and Bolsters: Stainless Steel
Pull: 5
Double Pinned Shield
Mill Relieved Liners
Flush in all 3 positions
Belt finish on the blade
$375 SOLD
*Satisfaction guaranteed. If you are not 100% satisfied with my work, contact me and I will be more than happy to work something out with you.
Questions and opinions are welcome!
Last edited:
:thumbup:
Wish I had the funds...
