Greetings BF,
It’s another fine day on these forums, and I’d like to take this opportunity to offer another little workhorse for your consideration, along with an oustanding new spydie.
Native 5 Salt - BNIB. LC200N steel. Mint. Only out of box for pics.
$OLD PP G&S insured & shipped USPS priority CONUS
Hinderer XM-18 3” slicer - USER. This knife has some mileage on it, but a whole lot left in the tank. Pivot, screws, clip, jade g10 scale, and blade all show wear. I’m sure the lockside has wear too, but the working finish helps cover that up for the most part. Blade shows plenty of scratches & marks, especially a whole lot near the tip on the presentation side of the blade (see close up pic). Detent lighter than the average XM. I use a flick of the wrist when flipping to ensure it deploys hard. Centering favors presentation side, but it doesn’t rub or impede function. Edge has just been professionally sharpened to a gleaming mirror, and hasn’t cut anything since. It’s ridiculous sharp & ready to go to work! I have the box (complete with oil stain) and peanuts put up in storage. I can send almost immediately in a generic soft zippered pouch, or given an extra day or two, can produce the box (buyer’s choice).
$OLD PP G&S gets it fully insured and shipped USPS priority CONUS
*In an effort to move along the Matt Bailey model 2.2 ‘geek’ that I have listed in the customs sub forum, I will entertain credible offers. Feel free to get in touch via PM
Thanks for the reads BF. Y’all rock!
It’s another fine day on these forums, and I’d like to take this opportunity to offer another little workhorse for your consideration, along with an oustanding new spydie.
Native 5 Salt - BNIB. LC200N steel. Mint. Only out of box for pics.
$OLD PP G&S insured & shipped USPS priority CONUS
Hinderer XM-18 3” slicer - USER. This knife has some mileage on it, but a whole lot left in the tank. Pivot, screws, clip, jade g10 scale, and blade all show wear. I’m sure the lockside has wear too, but the working finish helps cover that up for the most part. Blade shows plenty of scratches & marks, especially a whole lot near the tip on the presentation side of the blade (see close up pic). Detent lighter than the average XM. I use a flick of the wrist when flipping to ensure it deploys hard. Centering favors presentation side, but it doesn’t rub or impede function. Edge has just been professionally sharpened to a gleaming mirror, and hasn’t cut anything since. It’s ridiculous sharp & ready to go to work! I have the box (complete with oil stain) and peanuts put up in storage. I can send almost immediately in a generic soft zippered pouch, or given an extra day or two, can produce the box (buyer’s choice).
$OLD PP G&S gets it fully insured and shipped USPS priority CONUS
*In an effort to move along the Matt Bailey model 2.2 ‘geek’ that I have listed in the customs sub forum, I will entertain credible offers. Feel free to get in touch via PM
Thanks for the reads BF. Y’all rock!
Last edited:
