Bottle Opening Folder! All Titanium Stonewashed Nakago

Daniel Fairly Knives

Daniel Fairly Knives

Full Time Knifemaker
Moderator
Feedback: +50 / =0 / -0
Joined
Jan 9, 2011
Messages
16,370
This ultralight EDC excels as a knife and bottle opener!

This versatile design is equally at home in the field, office, campsite, kitchen, boat or spacecraft. :) It's very pocket friendly with a thick yet discreet deeply contoured clip. Watch/change pocket friendly size!

Materials Used - Titanium!

.125" Ti Blade with 72 RC Carbide Edge
.125" Ti Frames
.16" Ti Clip and full length Ti backspacer
Ti Screws
Ti Stop Pin

The only non Ti components are the heat treated stainless steel pivot barrel and the washers! No need to worry about rust and the knife is virtually maintenance free.

Weight - 2.5 ounces!

2.5" Blade
5.8" Total Length

Chisel Grind with 72 RC Tungsten Carbide Edge - True chisel geometry for aggressive cutting.

These have a ton of work into them and offer a very high level of fit and finish at a Fairly Knives "gateway" price! :)

6al4v Titanium with 72 RC Tungsten Carbide Edge - excels with abrasive materials such as cardboard, very aggressive with meat, seatbelt material, vegetables, cloth, cord, softer materials, rope, raw bone, paper, etc...

These are easy to sharpen with most any setup, just raise a burr by sharpening the microbeveled side only (reverse of the carbide) then strop or hone the burr off The carbide will not wear off, flake, chip, etc and is an integral part of the knife

$225 at www.fairlyknives.com USA shipping is included - International shipping is available








Please be sure to check the link to video, I'm having trouble editing pics but the video goes over the knife pretty well and is quick ---> [video]https://www.instagram.com/p/BEwQ2dKI-RT/[/video]
 
SaraLikesKnives said:
I only see the two pics of it open, where is the bottle opener portion located?
Click to expand...

Hi! Look out for more pics later, I'm working on getting some more up.

I posted a link at the bottom of my post with a brief video that shows the tang... I'll also get one of it opening a bottle. Big thanks for the inquiry!
 
Here's one of the opener up close on this same knife but with a different pivot and finish...

I have been using the same opener geometry in all of my KCT and Bottle Opening Knife designs, I'd put the opening geometry up against anything on the market, it is very effective.

 
This folder contains many ideas that make it special ! Just that exterior finish is a change from what others are doing that adds texture. The blade edge treatment is old hat for Daniel who gives you a knife he can gaurantee the quality of even the cutting edge. It's one of those truly custom made folders that is made for every day use and here in this site at at a terrific price.
I'm wishing you lots of sales Daniel. You've certainly made one that is super special !
Frank
 
Frank Niro said:
This folder contains many ideas that make it special ! Just that exterior finish is a change from what others are doing that adds texture. The blade edge treatment is old hat for Daniel who gives you a knife he can gaurantee the quality of even the cutting edge. It's one of those truly custom made folders that is made for every day use and here in this site at at a terrific price.
I'm wishing you lots of sales Daniel. You've certainly made one that is super special !
Frank
Click to expand...

Thanks Frank, that means a lot coming from you. :cool:
 
You must log in or register to reply here.
Back
Top