Just finished this one up, but i had to use an old camera for the pics so there horrible
Its made of 312 layers of 15n20, and 1084 which i twisted a few times throughout the welding of it
. The guard spacer and blade all came from the same billet. The knife is 10 7/8'' o.a., and the blade is 6 1/4'' tip to guard. The spine is 3/16'' at the plunge, and tapers toward the tip.
I flat ground the blade and then just slightly convexed the edge only. It has been etched and cold blued to give more contrast to the pattern.
The handle is african black wood with a 3/32'' nickle silver pin.
Price w/sheath is $270 shipped
Its made of 312 layers of 15n20, and 1084 which i twisted a few times throughout the welding of it
. The guard spacer and blade all came from the same billet. The knife is 10 7/8'' o.a., and the blade is 6 1/4'' tip to guard. The spine is 3/16'' at the plunge, and tapers toward the tip.
I flat ground the blade and then just slightly convexed the edge only. It has been etched and cold blued to give more contrast to the pattern.
The handle is african black wood with a 3/32'' nickle silver pin.
Price w/sheath is $270 shipped
Last edited:
