Busse ASH-1, .320, 'Custom' FInish, Mashed Cat +

Feedback: +16 / =0 / -0
Joined
May 22, 2002
Messages
605
A nice ASH-1

- .320 INFI
- Black MAGNUM handle, which was polished by the PO, and I roughened the
high-points a bit...
- Originally had an OD finish, but the PO carefully stripped the finish, leaving
a nice, smooth finish. It's a great effect, having a sorta non-glare, nice 'n
smooth finish! This one had, quite apparently, been finished to a good
degree prior to coating. *Logo is very-much in-tact and visible! There are
some striations in the spine, where it had not been finished-to-smooth,
again a cool effect. The handles were NOT removed when the original finish
was removed. Thus, the coating remains in-place under the slabs, providing
corrosion resistance. - I must say, this would be my much-preferred
finish. It is a kinda matte-silver-gray with a nice hint of sheen... Nice.
- Edge is clean and without compromises.
- Has a very-cool D-Guard, and lanyard, by Mashed Cat. - New.

- New Mashed Cat ASH1-specific kydex sheath slotted for leg-strap, with
TekLok and the drop-leg mount, along with the leg strap. This full set-up
was almost $100. Used briefly, essentially new. *This sheath was
specifically formed to accommodate the D-Guard mount link, which is
necessary for proper clearance.

NO visible flaws, of any kind, anywhere on knife or sheath.

- ***SOLD*** for the whole rig, shipped via USPS Priority, insured, to the CONUS


{Yes, IF someone makes the right offer on the knife-only, I would then be
pleased to sell the sheath separately. Interest will be honored on an
as-presented basis.}

DSCN7829.jpg

DSCN7828.jpg

DSCN7827.jpg

DSCN7826.jpg

DSCN7825.jpg

DSCN7824.jpg

DSCN7823.jpg

DSCN7822.jpg

DSCN7821.jpg

DSCN7818.jpg
 
Last edited:
Eased down a bit.....

$440.

{Available, unless one of the respondents/inquirers make the move first...}
 
Back
Top