Busse ASH1 drill the tubes! Add the screws!!

[shigawire4sure]

Could you tell us exactly what you needed to pull this off? I have the exact knife(actually 2) that you have there and would like to do this. Drill bit size,screw size...would really help.

 

[Justabuyer]

Could you tell us exactly what you needed to pull this off? I have the exact knife(actually 2) that you have there and would like to do this. Drill bit size,screw size...would really help.

Hand drill
Drill bit just a little to big to fit down the inside of the tube.

Drill into the tubes until the flared part spins off. I don't know what size I never looked. Its not really that critical.

Pry the grips off carefully

Go to www.USAknifemakers buy some nuts and screws from Tracy and bolt the grips back on. Thats it

 

[Sagittarius]

Not to rain on anyone's parade but I like the look of the tubes better.


Sag.

 

[Justabuyer]

Not to rain on anyone's parade but I like the look of the tubes better.


Sag.

Well there you go ...room for everybody.

 

[Bigfattyt]

I like the screws for fasteners. They look great. I have found, however, that the tube fasteners are very useful for putting cord through, etc.

 

[Justabuyer]

I like the screws for fasteners. They look great. I have found, however, that the tube fasteners are very useful for putting cord through, etc.

Surely are....but then again there is still a surplus of holes on the Knife.