Bill Siegle
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 3, 2000
- Messages
- 6,815
Here is a cool concept blade I made recently. It’s based off an old Tru Balance design. I wanted a throwing knife but with some albeit limited use as a camp knife. This is what I’ve come up with 
It’s 11 3/4in overall with a 7 1/4in blade tip to handle. The blade bevels are flat ground to a zero edge then sharpened at 20 degrees on each side for the secondary bevel. The blade is .200 thick 5160. The scales are black G10. The weight is 13oz. It balances on my finger between my name stamp and the apex of the “guard hump”. The sheath is black Boltaron and will accommodate a large size Tek Lok or similar device. My price is $225 ***sold***
shipped in the USA.
It’s 11 3/4in overall with a 7 1/4in blade tip to handle. The blade bevels are flat ground to a zero edge then sharpened at 20 degrees on each side for the secondary bevel. The blade is .200 thick 5160. The scales are black G10. The weight is 13oz. It balances on my finger between my name stamp and the apex of the “guard hump”. The sheath is black Boltaron and will accommodate a large size Tek Lok or similar device. My price is $225 ***sold***shipped in the USA.
Last edited:
