Camullis CAM1A1 Help

Discussion in 'Camillus Collector's Forum' started by KD8FCO, Sep 23, 2018.

  1. KD8FCO

    KD8FCO

    4
    Sep 23, 2018
    All:

    New to the forum and I have a question. I have a Camullis CAM1A1 and it is missing the retainer for the wire cutters. I am hoping that either someone has a spare or can offer some close ups and measurements of the metal part that retains the wire cutters. I will attach a photo of the missing part if I can (no luck so far). Thanks for any help in advice.
     
  2. Phil Gibbs

    Phil Gibbs Cutlery Student Platinum Member

    Nov 11, 1998
    If you have access to a wire EDM I can send you the toolpath for the die that blanked them.
    Teat treat & temper to 45 Rc.
    Latch for Bladeforums.jpg
     
    eveled likes this.
  3. KD8FCO

    KD8FCO

    4
    Sep 23, 2018
    That is awesome! I'll take whatever information that you can share. Do you have the above in a PDF form? Thank you!
     
  4. Phil Gibbs

    Phil Gibbs Cutlery Student Platinum Member

    Nov 11, 1998
    Give me your email & I will send you the pdf.
     
  5. Vit_213

    Vit_213

    709
    Feb 4, 2011
    {I don't understand anything}
    [​IMG]
     
    Last edited: Oct 24, 2018
  6. KD8FCO

    KD8FCO

    4
    Sep 23, 2018

    If I can figure out how to send you a PM I will....
     
  7. KD8FCO

    KD8FCO

    4
    Sep 23, 2018
    Phil - can you fab the this part, with the appropriate heat treat and parkerizing? If so, how much to get it done?
     
  8. Phil Gibbs

    Phil Gibbs Cutlery Student Platinum Member

    Nov 11, 1998
    I can't make it affordably!!
     

Share This Page