THESE ARE USED TO REMOVE A WARP FROM A HEAT TREATED KNIFE BLADE. SEVERAL VIDEOS ON YOUTUBE.....SELL FOR $150!!!!!
I was in need of a carbide straightening hammer so I made a few. NOT EASY I WILL SAY!! They are drilled and PRESS FIT with a 6 ton press. I did add an adhesive but definitely not necessary.
These are 8oz ball peen hammers with a 3/8" SOLID CARBIDE ball bearing. Handles are finished in AXE WAX! These are the highest quality ball bearings available.
Size: 3/8" (0.375" inch)
Grade: G25
Hardness: 90 Rockwell
Sphericity: 0.000025
90Rc.
PRICE IS $90 each SHIPPED. PM IF INTERESTED
I was in need of a carbide straightening hammer so I made a few. NOT EASY I WILL SAY!! They are drilled and PRESS FIT with a 6 ton press. I did add an adhesive but definitely not necessary.
These are 8oz ball peen hammers with a 3/8" SOLID CARBIDE ball bearing. Handles are finished in AXE WAX! These are the highest quality ball bearings available.
Size: 3/8" (0.375" inch)
Grade: G25
Hardness: 90 Rockwell
Sphericity: 0.000025
90Rc.
PRICE IS $90 each SHIPPED. PM IF INTERESTED
