Carbon Fiber Striper Slip Joint Knife

[T.A.DAVISON]

Todd Davison - striper slip joint knife.

Folder - #1038

~~ $500.00 ~~

Sold - Thank You!

Scales - Carbon Fiber, Green G-10 & Steel (stripes - all pinned)
Steel - 3/32 ATS34 Rc. 60 - 61
Bolsters & Liners - stainless ..........Shield - none
Closed - 4''
Hollow Ground, ...... Bead Blasted Finish, ....... Cryogenic Quenched
Half Stop, ......... Very nice walk & talk
Closes dead center.
Shipped in a protective case.
You can say I'll take it here.
Pay Pal is preferred.

Any questions or comments are welcomed.
Thanks for the looks.​

 

[Bob Carter]

The hits just keep coming Todd. Fantastic work!!!

 

[N.E.Tim]

Todd,
The photo looks great, I bet the knife is pretty FLASHY in hand.
Probably even better in sunlight. Nice clean lines.

 

[JTR357]

Wow,it doesn't get any classier than that!

 

[jaymeister99]

Again another slipjoint in carbon fiber that looks amazing. Gorgeous work.

 

[N.E.Tim]

Todd,
I have been watching this for a couple days.
( I can't believe this is still here ).
This is REALLY A GREAT LOOKING KNIFE.
I'LL TAKE IT.
I might have to buy a tuxedo to carry this.

 

[T.A.DAVISON]

Todd,
I have been watching this for a couple days.
( I can't believe this is still here ).
This is REALLY A GREAT LOOKING KNIFE.
I'LL TAKE IT.
I might have to buy a tuxedo to carry this.

You got it Tim & Gwen.....

I'll mark it sold for you - -:thumbup:

Thanks!

I appreciate the replies everyone - thanks!!!!!