Case 6332 in One Clip Blade ( SOLD )

[joebonny]

Happy 2014 to All. What I have for sale is a one blade on a Case 3262 pattern. The steel is 3/32 thick from CPM-154 steel. After all heat treatments temper is 59-60 on RC. The open length is 6 1/8" with a 3 1/2 " in the closed position. The double bolsters are hand sanded to 6000 grit as well as the badge shield an inside spring area. The stag bolsters are nice, with a little separation on one side but it is glued an pinned in place , because of this defect I will take $100.00 dollars off my original asking price which would have been $450.00. The pivot area has a bronze aluminum bushing an the opening an closing is around a 3 with nice snap in all three flush positions. This is the idea carry knife , both ends are pinched for pocket comfort. Has Serial number an Letter of Authenticity. Comes in Black leather zip pouch. asking ( SOLD ) shipped --pay pal preferred -money orders also. send to ( joeallenknives@insightbb.com ) for pay pal. Thank You & God Bless Everyone this New Year.

 

[Bladeplay74]

Joe -- this is such an attractive offering. I know it's tiresome to hear without a request to purchase, but I think it's terrific.

Seth

 

[joebonny]

Thanks Seth , yes its a great knife except that small separation.

 

[tleav61]

Joe, they just keep getting better and better. Great job on this one!

Todd

 

[Matteo Escobar]

Is the shield pressed and glued or pinned?

 

[joebonny]

Good question Matteo. The shield is inlayed down in the bone about .035 thousands of an inch an has Two stainless 1/16" pins drilled threw the shield, an bone, an liner an peened together on both sides. You can't see them on this shield, sometimes if you don't peen them right you can see the outline ring of the pin. I got lucky on this knife no rings on shield , but failed on the liner not getting it tight like it should have been. I am open to any offers to buy because of the liner defect. Thank You.