- Joined
- Jan 24, 2011
- Messages
- 389
Not looking for multiple knife trades. I’d be willing to trade two of these, or all three, for the right framelock flipper.
1. Brand new CKF T14 in M390. Comes with pouch, cloth, COA, extra clip, bearings, pivot, standoff, and other small parts.
https://imgur.com/a/vFMyil7
2. XM-18 3.5” DLC sheepsfoot
Got this on trade but already have a couple 3.5” XM-18s. Doesn’t come with box, but it will come with Teflon washers, phosphor bronze washers, and it has bearing installed on it now. There’s one small mark on the lock side which can be seen in the video.
!!SOLD!!SOLD!!SOLD!!
https://imgur.com/a/EfWWmk0
3. XM-18 3.5” DLC spanto with Ti scale and bronze titanium hardware.
Don’t have the box, but it will come with the Teflon, and phosphor bronze washers. The previous owner sanded down the jimping on the flipper tab to take off the sharp edge, you can see a close up of this in the video. With the cost of the knife, scale, and Ti hardware kit there’s close to 800.00 in this knife.
!!!!SOLD!!SOLD!!!!
https://imgur.com/a/SW6Xcne
1. Brand new CKF T14 in M390. Comes with pouch, cloth, COA, extra clip, bearings, pivot, standoff, and other small parts.
https://imgur.com/a/vFMyil7
Got this on trade but already have a couple 3.5” XM-18s. Doesn’t come with box, but it will come with Teflon washers, phosphor bronze washers, and it has bearing installed on it now. There’s one small mark on the lock side which can be seen in the video.
!!SOLD!!SOLD!!SOLD!!
https://imgur.com/a/EfWWmk0
Don’t have the box, but it will come with the Teflon, and phosphor bronze washers. The previous owner sanded down the jimping on the flipper tab to take off the sharp edge, you can see a close up of this in the video. With the cost of the knife, scale, and Ti hardware kit there’s close to 800.00 in this knife.
!!!!SOLD!!SOLD!!!!
https://imgur.com/a/SW6Xcne
Last edited:
