clip point for all weather

Status
Not open for further replies.
bikermikearchery

bikermikearchery

Feedback: +27 / =0 / -0
Joined
Jan 18, 2007
Messages
1,976
5/32" thick CPM154 steel heat treated and Cryoed to approximately 59RWC
4.5" of hollow ground working edge. 9.5" overall.
high density rubber handle (stall mat) This is one of the most comfortable
handle materials I have ever used.
pinned with marine grad brass tubing. accompanied by a stainless steel
marlin spike. In a kydex sheath with my own design of belt loop. This is a
package I put together to handle wet weather and hard work.
sold in the USA
 

Attachments

  • IMAG0003.jpg
    IMAG0003.jpg
    34.2 KB · Views: 974
  • IMAG0002.jpg
    IMAG0002.jpg
    32 KB · Views: 265
Last edited:
Any possibility of that knife being available with a 3.75" blade? Also, how much does the marlin spike cost by itself? That setup would be handy at work(structural ironworker).
 
I can always do a custom knife PM if your interested.

I have one extra spike all by its lonesome, stainless, 5 3/4" long, 5/16" thick. for $25.00

There have been some positive response with the spikes. I made 6 to start with and they all found good homes. I enjoyed making the spikes so I'll be making a second batch.
 
fitzOdaggers said:
whats the spike intended for??? (sorry for the dumbass question)
Click to expand...
Not a dumb question at all. Marlin spikes are intended for rope work. Working a knot out, splicing, etc. when you have one around you start finding lots of uses for them. I used mine today as a wedge to adjust a door.
 
I too would like a spike.....
Please PM me your price and paypal details.....
Thanks Steven
 
Status
Not open for further replies.
Back
Top