Robert Erickson
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 2, 2014
- Messages
- 2,882
Hey guys,
I just finished this one up. It's a clip point hunter in Alabama Damascus steel which was heat treated by Peter's to RC60. The handle is African Blackwood and the guard is bronze. It comes with a handmade leather sheath.
SPECS:
OAL: 10"
BLADE: 4 3/8" long, 1 3/8" wide. Compound Full flat and convex grind down to 0.012", hand sanded, Ferric Chloride etched. The spine thickness is 5/32" and has been slightly rounded.
STEEL: 5/32" Alabama Damascus steel heat treated to RC60
HANDLE: African Blackwood, bronze guard, pin and spacer with an additional black micarta spacer.
SHEATH: Handmade leather
$285 Shipped CONUS, international buyers welcome shipping extra.
Paypal, checks or money orders accepted.
Post "I'll take it" here in this thread and then PM or email me for arrangements.
Comments/Questions/Critiques welcome.
Thanks for looking!
I just finished this one up. It's a clip point hunter in Alabama Damascus steel which was heat treated by Peter's to RC60. The handle is African Blackwood and the guard is bronze. It comes with a handmade leather sheath.
SPECS:
OAL: 10"
BLADE: 4 3/8" long, 1 3/8" wide. Compound Full flat and convex grind down to 0.012", hand sanded, Ferric Chloride etched. The spine thickness is 5/32" and has been slightly rounded.
STEEL: 5/32" Alabama Damascus steel heat treated to RC60
HANDLE: African Blackwood, bronze guard, pin and spacer with an additional black micarta spacer.
SHEATH: Handmade leather
$285 Shipped CONUS, international buyers welcome shipping extra.
Paypal, checks or money orders accepted.
Post "I'll take it" here in this thread and then PM or email me for arrangements.
Comments/Questions/Critiques welcome.
Thanks for looking!