Clip point

PMLKnives

PMLKnives

Joined
Jun 22, 2007
Messages
721
This is one kinda off the cuff. I started with a design similar but when I realized there'd be lots of wasted steel I stretched and played until this is what came out.
specs.
3/16" ATS 34
6 5/8" overall
2 3/4" blade machine satin
the flats still have the mill scale
green and tan Mycarta
SS pins lanyard hole with reflective paracord(glows in the dark alittle)
comments and feed back please
Thanks for looking
Paul
 
Your knives look great. You should sell a few on this forum. I bet they would sell fast.
 
Nice knife, the blade is appealing looking style and finish wise to me. The only thing that does'nt work for me is the way the tang finishes in the end of the scales. It would seem to dig in to the hand in hard use; maybe round it downward, or just round it off.
 
a couple with the finished sheath. Leather work is definately fun even if I'm not great at it.
 
You must log in or register to reply here.
Back
Top