Combat Axe and two Nasty Neckers

[Ansoknives]

First is a Combat Axe. It is made from 1/4" S30V, 60Rc and cryotreated. The handle is brown burlap Fibermascus. The flats are beadblasted and the grinds are brushed...The Axe is razor sharp on the main edge and the spike is ground abit steeper to get a strong yet still sharp tip. It comes with a kydex beltsheath and can be carried both handle up and down. Will also attach well to a backpack.

 

[Ansoknives]

Next is a couple of Nasty Neckers.

nr1:
Long slender Nasty here....blade is 3.5" and overall is approx 10". The textured part is brushed and the hollows are handrubbed. It is made from 1/5" RWL-34 stainless powder steel at 60Rc and cryotreated. Multiposition kydexsheath (the clip has 3 holes and can be moved around .)

nr2:
Curved Hawkbill Nasty here....blade is 3" and overall is approx 9". The textured part is brushed and the hollows are handrubbed. It is made from 1/5" RWL-34 stainless powder steel at 60Rc and cryotreated. Multiposition kydexsheath (the clip has 3 holes and can be moved around .)

Thanks for looking!

 

[Temper]

It's bloody hard to express admiration over the net. Everything I have seen on this forum has blown my mind. I love the handle on the neckers, pleasing to the eye, functional and without any waste or fuss. Superb!

 

[Ansoknives]

thank you Temper....they are very nice to hold and surpricingly handy and usefull

 

[Andrew Lynch]

Again, I'm blown away...by all of them.

Like I said in another thread however, I'd like to see a real hard-use steel in the axe! S30V is tough for stainless, but a good carbon would be much better.