Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,176
I thought it was time to make a medium sized combat/fighter knife . This is what I came up with . The steel is D-2 with G-10 handle material secured with Corby bolts and 2 ton slow cure epoxy . Thumb groves in the spine and groves in the handle for extra grip in wet conditions.
Specs are
O.A.L is 9-1/2" 3/16" full tang , 1-1/4 wide at Ricasso
Blade is 4-3/4" to center of handle , D-2 with a Paul Bos H.T at an RC 60 , cyro
Bottom sharpened edge is 4-1/2" and top edge is sharpened 2-3/4 back with a 3" back grind .
This is hollow ground with a fine scotch bright satin finish.
Handle is Black/Blue G-10 with 1/4 Corby bolts.
With a hand made leather sheath
$185.00 plus $ 5.00 for shipping . Allow 7 days to make sheath .
With a spec-op ACU pattern sheath , $ 235.00 plus $5.00 for ship next day.
Payment by pay-pal , postal M/O , or check with time to clear.
Thanks all for looking . OK. I will pay for shipping SOLD
Specs are
O.A.L is 9-1/2" 3/16" full tang , 1-1/4 wide at Ricasso
Blade is 4-3/4" to center of handle , D-2 with a Paul Bos H.T at an RC 60 , cyro
Bottom sharpened edge is 4-1/2" and top edge is sharpened 2-3/4 back with a 3" back grind .
This is hollow ground with a fine scotch bright satin finish.
Handle is Black/Blue G-10 with 1/4 Corby bolts.
With a hand made leather sheath
$185.00 plus $ 5.00 for shipping . Allow 7 days to make sheath .
With a spec-op ACU pattern sheath , $ 235.00 plus $5.00 for ship next day.
Payment by pay-pal , postal M/O , or check with time to clear.
Thanks all for looking . OK. I will pay for shipping SOLD
Last edited: