Cool little Bird and Trout/EDC in Black (sold)

A

Alan Warren Knives

Feedback: +62 / =0 / -0
Joined
Dec 31, 2009
Messages
2,630
Hello again Folks, Hope you like this little beauty. Although I try to put the best finish on my knives that I am able, they are made to be used. The first (I will Take it) gets it.

Blade is CPM 154 .107 thick and 3.187 tip to bolsters. O/A is 7.25. Heat treated w/cryo quench and double tempered to 60-61 RC. I work the blade to a polish and then finish with 2000 grit. I hollow grind the tang so the adhesive has a place to stay leaving about .187 wide flat from the edge in all around. Tang is tapered of course.

Bolsters are of CF held tight with .093 bronze welding rod.

Handle is Black G10 w/.014 yellow G10 liners, stainless pins and lanyard hole.

Sheath is of 8-9 ounce hand tooled and hand stitched leather. I use sole leather for the Loveless cam idea. The knife click fits into place and is held very secure yet is easy to withdraw. I have seen many of my knives after many years of use and the sheath has still maintained the same secure fit.

Asking (sold) shipped conus priority insured US Mail. My paypal is warrencustomknives@yahoo.com Thank you all for looking and comments are always welcome. Alan
 
Last edited:
Alan,
Your knives are WELL DESIGNED and EXTREMELY WELL CRAFTED.
Also Your leather work is SPECTACULAR.
 
You must log in or register to reply here.
Back
Top