- Joined
- Dec 31, 2009
- Messages
- 2,630
Hello to All, I was inspired a long time ago by D-Holders work with stacked handle knives, and the multitude of colors that can be used. This knife is built very solid and made to be used.
Hope you like it.
Blade is CPM 154 .202 thick, and 4.125 tip to guard. O/A is 8.875. Heat treated with subzero quench, and double tempered. RC is 60-61. Hand finished with 2000 grit. Grinds are dead center with 10 in. wheel.
Guard is 416 very carefully silver soldered. Fillet is full and even all around. Blade is perfectly perpendicular with the front of the guard.
Handle is of Very nice ironwood, with African Black wood, Fossil Walrus, thin black G10, and brass accents. Pommel is 7075 aircraft aluminum.
Sheath is hand tooled, and hand stitched 8-9 ounce leather.
Asking (withdrawn) shipped in the USA. My paypal is warrencustomknives@yahoo.com
Thanks for having a look. Comments always welcome. Alan
Hope you like it.
Blade is CPM 154 .202 thick, and 4.125 tip to guard. O/A is 8.875. Heat treated with subzero quench, and double tempered. RC is 60-61. Hand finished with 2000 grit. Grinds are dead center with 10 in. wheel.
Guard is 416 very carefully silver soldered. Fillet is full and even all around. Blade is perfectly perpendicular with the front of the guard.
Handle is of Very nice ironwood, with African Black wood, Fossil Walrus, thin black G10, and brass accents. Pommel is 7075 aircraft aluminum.
Sheath is hand tooled, and hand stitched 8-9 ounce leather.
Asking (withdrawn) shipped in the USA. My paypal is warrencustomknives@yahoo.com
Thanks for having a look. Comments always welcome. Alan
Attachments
Last edited:
