- Joined
- May 15, 2007
- Messages
- 611
Here is a classy chopper that is set up for crossdraw wear. The O1 blade is flat ground with a little thicker than normal edge so as to be a good chopper. The handle has a nice curvature that aside from being really comfortable, also puts the point a bit low which produces power in the cut.
Check her out and as always, thanks for looking!
Specs:
Flat Ground from O1 Tool Steel 1/4" Thick
Differential Heat Treat
Hand Rub Finish on Blade and Fittings
9 3/4" blade (tip to bolster) 9" of Cutting Edge
15" OAL
416 Stainless Bolsters
Mosaic Pins
Ironwood Burl Handle Scales
Vine Filework
Crossdraw Pouch Sheath
Asking $525.00 ***Sold***
Paypal and M.O. accepted
PP to: angel_kissed_me@yahoo.com (please note the underscores)
Check her out and as always, thanks for looking!
Specs:
Flat Ground from O1 Tool Steel 1/4" Thick
Differential Heat Treat
Hand Rub Finish on Blade and Fittings
9 3/4" blade (tip to bolster) 9" of Cutting Edge
15" OAL
416 Stainless Bolsters
Mosaic Pins
Ironwood Burl Handle Scales
Vine Filework
Crossdraw Pouch Sheath
Asking $525.00 ***Sold***
Paypal and M.O. accepted
PP to: angel_kissed_me@yahoo.com (please note the underscores)






Last edited: