Les Voorhies
BANNED
- Joined
- Nov 30, 2003
- Messages
- 564
I've been making blades for the do-it-yourselfer for a few months and i've got a couple oddball blades for sale, they are both made from 1075 carbon steel and are heat treated and sharpened.
The 1st one is 8.5" overall, 3/16" thick, 3.5" blade, satin finished, drilled for 3/16" pins. The swedge is whats odd about this one, it was supposed to be much smaller but it got out of hand but its neat and pretty even.
Sorry about the photos
Price is SOLD
The 2nd one is a left over from some neck knives i made a few years ago, I didnt finish them at the time because they didnt clean up well and i couldnt get a decent finish on them, this one is no excepton, the finish is not up to my standards, its not "bad" it's just not "good". It's 1/8" thick, 3.5" chisel ground tanto blade, 7.75" overall, drilled for 1/8" pins.
Price is SOLD
Thanks for looking
The 1st one is 8.5" overall, 3/16" thick, 3.5" blade, satin finished, drilled for 3/16" pins. The swedge is whats odd about this one, it was supposed to be much smaller but it got out of hand but its neat and pretty even.
Sorry about the photos
Price is SOLD
The 2nd one is a left over from some neck knives i made a few years ago, I didnt finish them at the time because they didnt clean up well and i couldnt get a decent finish on them, this one is no excepton, the finish is not up to my standards, its not "bad" it's just not "good". It's 1/8" thick, 3.5" chisel ground tanto blade, 7.75" overall, drilled for 1/8" pins.
Price is SOLD
Thanks for looking
