- Joined
- May 12, 2012
- Messages
- 846
Hi everyone, here is the second finished knife in a small run of four in this design that I am making. I designed these knives to be small, lightweight, capable of precision cuts while remaining very tough and able to put up with lots of abuse. They are not a straight sheepsfoot, they have a bit of belly. I personally use one of the same design in my shop all of the time.
Specs
Steel: 3/32" CPM 3V @ 60Rc Heat Treated by Peters
Grind: Right Hand Chisel FFG with screaming sharp convex edge
Handle: 1/8" Red G10 with .060" black G10 liners
Hardware: Stainless pins and lanyard tube
Finish: Scotchbrite belt finish
7" OAL, 3" cutting length, 1" tall
4.5oz /w sheath
This one is $180 shipped CONUS with tracking and insurance. I take Paypal, USPS MO and cashiers check. First "I'll take it" gets it. My email is markellmtthw@aol.com. Lifetime common sense warranty with free sharpening.
Kydex sheath included. I made a paracord belt loop system for it, it works very well for left and right hand vertical or horizontal carry but if you don't like it the sheath is small and large TekLok compatible. Excellent retention, you could carry this as a neck knife.
PICTURES!
Specs
Steel: 3/32" CPM 3V @ 60Rc Heat Treated by Peters
Grind: Right Hand Chisel FFG with screaming sharp convex edge
Handle: 1/8" Red G10 with .060" black G10 liners
Hardware: Stainless pins and lanyard tube
Finish: Scotchbrite belt finish
7" OAL, 3" cutting length, 1" tall
4.5oz /w sheath
This one is $180 shipped CONUS with tracking and insurance. I take Paypal, USPS MO and cashiers check. First "I'll take it" gets it. My email is markellmtthw@aol.com. Lifetime common sense warranty with free sharpening.
Kydex sheath included. I made a paracord belt loop system for it, it works very well for left and right hand vertical or horizontal carry but if you don't like it the sheath is small and large TekLok compatible. Excellent retention, you could carry this as a neck knife.
PICTURES!
Last edited: