CPM and orange G-10

PMLKnives

PMLKnives

Feedback: +15 / =0 / -0
Joined
Jun 22, 2007
Messages
721
I've got two available with some orange G-10.

First up it a warncliff style made from 3/16" CPM 3V. 6” overall with 2 ¼” blade. The hollow grinds have a been ground up to a 400x belt then buffed with the cork belt. I have left the millscale on the flats, then bead blasted, and lastly touched to the scotch brite belt. I have also put a flat end screw driver on the butt. Thumb checkering, Kydex sheath and a lanyard knot to finish it up.
sold
Second is a drop point from 5/32" CPM154, 6.5" with a 3" blade. This has been treated same as the first. Only no screw driver end. Two tone finish thumb checkering and kydex.
sold
Thanks for looking:thumbup:
Paul
orangeg10001.jpg

orangeg10002.jpg

orangeg10003.jpg

orangeg10005.jpg
 
Last edited:
I just bought an orange military, which I thought was going to be my last knife for awhile. But, if that orange warncliffe is still around when I get my check from uncle sam I might have to get it.
 
For anyone who is on the fence: Paul does top notch work! Super sharp with real clean Fit and Finish. His handle designs just melt into your hand! Dont be afraid to jump on that amazing Wharny!!! :thumbup:
 
Nice work! I get surprises everyday when I visit this part of BF and this is just one. I have already bought 5 knives this month thru BF. Got to wait until next month to screw up that month's budget.
 
I like this knife alot. Will the holes in the sheath line up with a tek loc to be worn on a belt?
 
You must log in or register to reply here.
Back
Top