CPM M4 Mesquite Hunter!SOLD

[samuraistuart]

This is my personal hunter model with a blade in CPM M4 and mesquite handles. It is full flat ground from relatively thin stock, so the edge is nice and thin for excellent cutting ability. Quite a few of my customers are using my hunters in the kitchen as well. They work great in the kitchen! I steer my hunter knife geometry towards the thin side, along with higher than average hardness levels. This blade was heat treated by Peter's Heat Treating Services, with cryo, to 64HRC. The edge thickness prior to sharpening was about 0.010", 0.020" is about 5/32" up, and 0.030" a full 1/4" up. Handle is mesquite with very nice color and figure to it, 800 grit finish, oiled, and satin poly for protection. Very comfortable in the hand. Sharpening was done with DMT DiaSharp plates from extra coarse thru extra extra fine, approx 3 micron. As always, this knife is extremely keen and sharp! "S Davenport" maker's mark on left side, "CPM M4" steel ID on right side.

OAL: 8 7/16"
Blade: 3 7/8"
Handle: 4 11/16" (measured from edge heel)
Thickness: 0.079" (tapered to point)
Edge: 30° inclusive, 3 micron

Price is only SOLD Included is a custom made kydex sheath with metal belt/boot clip, and free shipping to your door anywhere in the USA! If you live elsewhere, just let me know and I will work out a shipping rate for you. Paypal preferred (samuraistuart@yahoo.com), but will be more than happy to take a personal check and then ship once cleared. Thank you for looking! I'm on Instagram: stuartalandavenport

 

[mb>]

Very nice. Can you post a pic of the spine/top of handle?

Edit: never mind. This one has my name on it. I'll take it.

Please confirm and I'll get you the $ sent over.

Mark

 

[samuraistuart]

Hey Mark, it's yours if you want it! Paypal address is at the bottom of the posting. It is also my email address. I'll mark this one as SPF for you.

 

[mb>]

Payment sent. Thanks Stuart.

 

[samuraistuart]

Got it. Thank you!