CPM S35VN necker in blue G10 and lizard kydex

Status
Not open for further replies.
Feedback: +39 / =0 / -0
Joined
Aug 25, 2009
Messages
2,834
Hello peeps, it's been a while but I'm back at it. I will be posting more blades tomorrow so if you like this one, be back tomorrow for more! As usual, Beckerheads and Ka-Bar Krew get a kewl 10% off, make sure to mention your #. First come, first served, follow thru with a pm to send you the paypal add.

This one was sent to Peter's for HT and came back at 61 Rc. Stock is a hair under 1/8", 6" OAL with a 3" blade. Some very faint scratches from the kydex, but this might be the best kydex I've done so far, a solid snap with no rattle. Blue dyed lizard skin riveted in place. Partially 3D'd blue and orange G10 scales secured with G Flex epoxy and stainless pins and a blue paracord lanyard complete the package. Asking $110 paypal net, shipped in the US. Thanks for looking and have a wonderful evening!

IMG_20160930_185019233_zpscxljtkuw.jpg


IMG_20160930_185039834_zpsf3eskuft.jpg


IMG_20160930_185049692_zpsk7prtgca.jpg


IMG_20160930_185138710_zpseue9yo64.jpg
 
thank you. I thought I would keep it but then again, I have to let them go so I can make some more, lol.
 
mmmm actually, bad cell phone pic. It's a conventional, albeit low, v edge, as this blade was ground thin. I'll post better pics later.
 
a better pic, although I don't have a problem turning the edge to convex if that is where the preferences lay:

IMG_20161001_164254225_zps4skmhbt1.jpg
 
lol. I had it with me 2 weeks ago, spending a week in Orlando and decided to visit the Randall factory. Both Randall brothers thought the same, but they liked the knife anyway :D
 
Status
Not open for further replies.
Back
Top