Cpm s35vn

[mete]

What's the status of this ? NSM lists it .Does anyone here use it ?

 

[Atlas Knife Company]

Damn, you beat me to the punch. I was just going to ask a similar question.

 

[KnifeMaker.ca]

We just ordered a sheet from SBSM. No feedback yet of course, but it is available.

Rob!

 

[dphillips]

I built a 3/32" thick with a 4" blade as a "try out" knife. To me it is easier to work than s30v, and polished better. Just did a machine finish. Haven't put it to any real use yet, so can't report on edge holding. I know its not much info, but its all I got for now.

 

[McAhron]

Love it.Better than s30v for the reasons dphillips stated.

 

[Gossman Knives]

I've got a thread on my forum about it. Very good steel from the testing I've done so far. Edge holding is exceptional.
Scott

 

[Atlas Knife Company]

Is it aimed more at fillet knives or machetes?

 

[3/16th's]

Hey Rob,

What dimensions are your sheet? If you have any left over, let me know!

Hugh

 

[KnifeMaker.ca]

Hey Hugh

Sheet is about .140 x 24 x 36. PM me. No problem.

Rob!