Robert Erickson
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 2, 2014
- Messages
- 2,882
Hi guys,
I've got a B&T in CPM154 steel up for grabs tonight. This would also make a great paring knife. It's finished in a plungeless design that is hand sanded to 800 grit. It was heat treated by Peter's to RC61. I obtained the micarta from @milanmozolic and it is reported to be from the 70's -80's. I've always wanted to use micarta cross cut and finally have a piece large enough to do so. It finished up very cool.
SPECS:
OAL: 8.5"
BLADE: 4" Long, 1" wide, full flat grind, 800 grit hand sanded finish, edge down to 0.08" before sharpening.
STEEL: 0.09" CPM154 heat treated by Peter's to RC61
HANDLE: Cross cut micarta from the 70's-80's. Bronze pins.
SHEATH: Kydex or pouch style leather sheath included.
$SOLD Shipped CONUS, international buyers welcome, shipping extra.
Post "I'll take it" here in this thread and then email or PM me for arrangements.
Paypal, check or money order accepted.
Comments/Questions/Critiques welcome.
Thanks!
I've got a B&T in CPM154 steel up for grabs tonight. This would also make a great paring knife. It's finished in a plungeless design that is hand sanded to 800 grit. It was heat treated by Peter's to RC61. I obtained the micarta from @milanmozolic and it is reported to be from the 70's -80's. I've always wanted to use micarta cross cut and finally have a piece large enough to do so. It finished up very cool.
SPECS:
OAL: 8.5"
BLADE: 4" Long, 1" wide, full flat grind, 800 grit hand sanded finish, edge down to 0.08" before sharpening.
STEEL: 0.09" CPM154 heat treated by Peter's to RC61
HANDLE: Cross cut micarta from the 70's-80's. Bronze pins.
SHEATH: Kydex or pouch style leather sheath included.
$SOLD Shipped CONUS, international buyers welcome, shipping extra.
Post "I'll take it" here in this thread and then email or PM me for arrangements.
Paypal, check or money order accepted.
Comments/Questions/Critiques welcome.
Thanks!
Last edited:
