Just finished, hot from the bench.
The blade is CPMS30V. 4-3/4" long, a pinch under 1" wide and 1/8" thick at bolster. It has a nice taper to the tip, flat bevels and thin edge. Hand rubbed satin finish with 800 grit.
About a year ago i sent a dozen of CPMS30V blanks to Paul Boss HT. That is one of them. Suppose to be 60HRC. I still have 5 unfinished blades and suppose they were treated by Paul.
The bolster is Stainless Steel as well as the butt cap. The blade has a tang that goes all the way through the handle and has a nut inside. Everything is assembled permanently with epoxy. Not a take down one.
I hand engraved the bolster and the butt cap. The background is removed\recessed and blackened. Than I shaded the design.
I sculpted the handle out of walnut crouch. Not a burl per say, but has nice and deep figure. I like the color of this particular piece. It is vacuum stabilized, polished with carnauba wax.
The sheeth is hand stiched and wet fitted to the knife. I dyed it, treated with leather balm and polished with carnauba wax. The design is carved. I tried to mimic the engraving on the bolster.
Overall that would be a great hunting knife. It has best steel blade with the best heat treatment. It is light and feels great in the hand.
This is One-Of-A-Kind knife(as usual), I quarantee that no copies will be made ever.
sold
I am asking $XXX for it, insured CONUS shipping included.
Pay-Pal preferred but I will accept a personal check ( will ship after the check is cleared).
Thank you!
The blade is CPMS30V. 4-3/4" long, a pinch under 1" wide and 1/8" thick at bolster. It has a nice taper to the tip, flat bevels and thin edge. Hand rubbed satin finish with 800 grit.
About a year ago i sent a dozen of CPMS30V blanks to Paul Boss HT. That is one of them. Suppose to be 60HRC. I still have 5 unfinished blades and suppose they were treated by Paul.
The bolster is Stainless Steel as well as the butt cap. The blade has a tang that goes all the way through the handle and has a nut inside. Everything is assembled permanently with epoxy. Not a take down one.
I hand engraved the bolster and the butt cap. The background is removed\recessed and blackened. Than I shaded the design.
I sculpted the handle out of walnut crouch. Not a burl per say, but has nice and deep figure. I like the color of this particular piece. It is vacuum stabilized, polished with carnauba wax.
The sheeth is hand stiched and wet fitted to the knife. I dyed it, treated with leather balm and polished with carnauba wax. The design is carved. I tried to mimic the engraving on the bolster.
Overall that would be a great hunting knife. It has best steel blade with the best heat treatment. It is light and feels great in the hand.
This is One-Of-A-Kind knife(as usual), I quarantee that no copies will be made ever.
sold
I am asking $XXX for it, insured CONUS shipping included.
Pay-Pal preferred but I will accept a personal check ( will ship after the check is cleared).
Thank you!
Last edited:
