Criswell Zombie Tactical Tanto Knife

Status
Not open for further replies.
robcriswell

robcriswell

Feedback: +5 / =0 / -0
Joined
Mar 29, 2012
Messages
65
This knife is made out of A-2 Steel, vacuum heat-treated and hardened to a Rockwell Hardness of 60HRC on the edge for maximum toughness & edge holding durability, then the back spine is softened for some flexibility to 58RC. Blade stock is 1/4" thick, 1 1/4" wide at the guard to 1" at the tip, the blade is hollow ground. The guard is Titanium with a full tang. The tang is mounted with G-10 strips and hand wrapped with paracord. Sheaths are G-10. The coating on the knives is a Cerakote Firearm coating from Rouge Tactical Coatings www.roguetacticalcoatings.com
These are handmade allowing for perfect balance. Each knife is razor sharp & has a great feel!knives april2012 015.jpgknives april2012 003.jpgknives april2012 002.jpgknives april2012 001.jpgZombie Knife 002.jpg
Japanese style point, tear drop style guard. 7" blade, 13" overall, 1.05 lbs. $175.00

If you would like to buy one of these please email me at rdcriswell@centurylink.net
 
Last edited:
Hey Rob you old fart. Where the heck is Criswell, Oregon? Is it next to Rob, Oregon? Glad to see you back to making again. Are you going to be in Eugene next weekend?
 
Creswell is 15 miles south of Eugene, My table is O07 and I will be there all weekend, Are you still beating on steel? I have switched to switchblades and folders too old for Swords!
 
Status
Not open for further replies.
Back
Top