- Joined
- Dec 21, 2006
- Messages
- 3,158
Not much to say about this knife, except what a pain in the butt it is to hand finish Cru Forge V at 64HRC!!! A few quick items of note: 1. The full flat grind went to zero before applying the edge bevel, a thin grind for high performance. 2. Sharpening was done with DMT Diasharp plates from C to EF for a nice clean apex on this vanadium steel, then polished on the Green Brick and Spyderco Fine ceramic. Crazy, crazy sharp! If you know Cru Forge V, you know it performs, and performs very well!
Included with this knife is a kydex sheath, complete with drainage hole and metal belt/boot clip, as well as shipping anywhere in the USA.
SOLD Paypal address: samuraistuart@yahoo.com
Thank you for your interest!
Stuart Davenport Knives
San Antonio, TX
OAL: 8 13/16"
Blade: 4 1/8" from plunge line
Handle: 4 9/16" Black G10, SS pins
Thickness: 0.100" at ricasso
Steel: Cru Forge V 64HRC
Edge: ~26° inclusive (13° per side)
Blade: 4 1/8" from plunge line
Handle: 4 9/16" Black G10, SS pins
Thickness: 0.100" at ricasso
Steel: Cru Forge V 64HRC
Edge: ~26° inclusive (13° per side)
Included with this knife is a kydex sheath, complete with drainage hole and metal belt/boot clip, as well as shipping anywhere in the USA.
SOLD Paypal address: samuraistuart@yahoo.com
Thank you for your interest!
Stuart Davenport Knives
San Antonio, TX
Last edited:
