Cryo heat treated Aeb-l Not santouko not a cleaver "SOLD"

DanGraves

Knifemaker / Craftsman / Service Provider
Feedback: +108 / =0 / -0
Joined
Mar 5, 2006
Messages
2,654
I just completed this one and hope you like it. Blade made from AEBL stainless that is Cryo heat treated. The blade has a cutting edge that is 6 3/4 inches in length and overall length is 11 1/2 inches. It is 2 inches wide and at spine is .150 thick which means it has a little heft to it. can chop small branches etc which kinda takes it out of the santouko league but not thick enough for a cleaver. Wide enough to make it a dream for cutting vegies and scooping them and for chopping meat up fine at the camp etc. It is flat ground and I did the grind to the quick. What I mean is the secondary bevel is very small because it was sharp before I sharpened it. The handle is Stabilized (by K & G) thuya burl with great figure.

"SOLD" and 8.00 for mail in USA . My paypal is dangraves4923@earthlink.net Thanks and enjoy the photo's I also take check or money order.




 
Last edited:
Awesome ! A pattern rarely seen, at that. Especially with a symetric flat grind.
 
Back
Top