1. Cultrotech Comrade:
Got this direct from Cultrotech via their pre-order and received it in March. This is #65 of (I believe) 100 made. This one has been carried a little but shows very little signs of it other than some pocket lint buildup on the inside that I'd rather not disassemble it again to clean. It has been disassembled once and that left some marks on the rear screw. I was very careful to handle all of the bearings with tweezers and it still has the same drop-shut action and rock solid lockup and centering from day one. The factory polished edge is un-touched other than about 5 strokes per side with a spyderco ultra fine rod to hone the apex. Still have everything it came with down to the cardboard box the fancy one came in. This one hurts to part with because it's so special and I got in on the pre-order, but I need the cash.
(SOLD for $600) Shipped in US. I will go international for this one but shipping would be on the buyer.
2. Spyderco Advocate:
This knife was purchused new from BladeHQ 10/2019. It has seen a slight bit of carry, but is like-new in all regards with a still razor sharp factory edge. I coated the blade with EDCi when I got it and cannot find any corrosion spots. Action, lockup, and centering are all as solid as they were when new. Only blem is a scratch by the thumb hole from when I slipped while knocking off the sharp corners with a ceramic rod (it's much more enjoyable to thumb-deploy now that that's done). Box and papers are included. I listed this for sale in January and got no replies, and it has not seen use since then.
SOLD for $150.
Got this direct from Cultrotech via their pre-order and received it in March. This is #65 of (I believe) 100 made. This one has been carried a little but shows very little signs of it other than some pocket lint buildup on the inside that I'd rather not disassemble it again to clean. It has been disassembled once and that left some marks on the rear screw. I was very careful to handle all of the bearings with tweezers and it still has the same drop-shut action and rock solid lockup and centering from day one. The factory polished edge is un-touched other than about 5 strokes per side with a spyderco ultra fine rod to hone the apex. Still have everything it came with down to the cardboard box the fancy one came in. This one hurts to part with because it's so special and I got in on the pre-order, but I need the cash.
(SOLD for $600) Shipped in US. I will go international for this one but shipping would be on the buyer.
2. Spyderco Advocate:
This knife was purchused new from BladeHQ 10/2019. It has seen a slight bit of carry, but is like-new in all regards with a still razor sharp factory edge. I coated the blade with EDCi when I got it and cannot find any corrosion spots. Action, lockup, and centering are all as solid as they were when new. Only blem is a scratch by the thumb hole from when I slipped while knocking off the sharp corners with a ceramic rod (it's much more enjoyable to thumb-deploy now that that's done). Box and papers are included. I listed this for sale in January and got no replies, and it has not seen use since then.
SOLD for $150.
Last edited:
