Custom Micarta Slip Joint Knife

T.A.DAVISON

T.A.DAVISON

Slip Joint Knife Maker
Feedback: +106 / =0 / -0
Joined
Oct 24, 2005
Messages
5,477
Todd Davison - custom slip joint knife.





Folder - #1247

~~ $525.00 ~~


Sold - Thanks ​




1247AAAA.jpg





Scales - Green Canvas Micarta
Steel - 3/32 cpm 154 Rc. 60 - 61
Bolsters & Liners - stainless - coined edge
Shield - stainless - inlaid & dbl. pinned
Long Pull
Closed - 3 7/8''
Hollow Ground, Hand Finish, Cryogenic Quenched
Half Stop, Nice walk & talk, Razor Sharp!
.....Closes dead center.
Shipped in a protective case.​

You can say I'll take it here.
Pay Pal is preferred.

Any questions or comments are welcomed.
Thanks for the looks.​








.
 
Last edited:
I'm new to knife collecting and to the forum. As we newbies tend to do, I've spent most of my spare time looking at knife porn. I've seen very few knives that could compete with that one when it comes to aesthetics and I'm sure it will perform equally as well. That is beautiful work.
 
I like that you only did the coining on the front 2/3rds of the liners instead of going all the way to the back end.
 
Todd,
This Folder is NEAT IN EVERY WAY END TO END. :thumbup: :thumbup: :thumbup: :thumbup: :thumbup:
BEAUTIFUL BLADE, NICELY SHAPED HANDLE.
I agree with Jake, the partial coined edge ENHANCES the handle shape.
 
Todd make the last few patterns in the 3.5in closed OAL range and my wallet will explode your direction.
 
I was just wondering how that blade would work with that handle shape. I must say, very well.

I like it, Todd. I like it a lot
 
About time this one sold!!! I signed up for a crap load of OT to grab this one...but I'm still waiting for my sweet one from you Todd.

Congrats to the buyer!!
 
Last edited:
You must log in or register to reply here.
Back
Top