Custom Skull-n-chains Flipper(SOLD)

[Quest Knives]

New CUSTOM Skull-n-Chains Flipper !
Front Handle 3D sculpted from G-10 Black/Toxic Green material
Skull-n-Chains Custom Engraving motif
Rear Frame titanium frame lock with stonewash finish
7.375" Overall length
4.25" Closed Length
3.0" Drop Point Blade x .125" thick
CPM 154 Stainless Steel blade with stonewash finish
Heat treated To 59 rockwell
Removable Pocket clip for tip up carry
Stainless Steel Caged bearings around pivot/ backed to ride on heat treated steel washers
Early Lockup
Dead center blade alignment
Heatreated Lockbar face

Cost: (SOLD)

Handcrafted By: Greg Goeckel, Designer, Engineer, Craftsman, and Knifebuilder
Authenticity card included

Free shipping within USA

First one to say “ I’ll take it” wins bid (SOLD)

Paypal: info@questknives.com
Website: www.questknives.com

 

[Lycosa]

Greg- This folder design is one of my favorites. You brought a new folder design to the table and that's not easy to do! You shall be congtatulated!
rolf

 

[Quest Knives]

Thx Rolf,,,,,,,,,its been a fun one to build.
Thanks for your continued support.......
Greg

 

[Kianson]

I really like the way the the toxic g10 contrasts but the engraving, in my taste, is a bit to much. other
than the engraving I love it. Does in run n washers or bearings or what?

 

[Kianson]

Or I would be more comfortable with it if the titanium side was textured in some way, still a beautiful knife

 

[Quest Knives]

This custom knife is running on stainless steel caged bearings .
Thx for your comments and feedback.
Greg