- Joined
- Dec 6, 2013
- Messages
- 2,782
1. Cutter's knife and tool Brend #2 D/A- Bead blasted 154cm blade. Full anodized ti frame. Uncarried, unused and unsharpened. Needs to be fully broken in still. Auto button is a little touchy.
One of the screws on the frame is marred. I have two, that's the only reason i'm puttin this one up. Comes with soft CKt case. 97% condition- $425 $375
2. Boker Rexford Vallotton conversion D/A- vg-10 blade, anodized ti frame. Scale release is LSCF and the leaf spring has been jeweled. The blade edge has been modded to be used as an auto. Also sharpened and had any rough spots smoothed out. This was done by Vallottons shop. So there are some handling marks over and above the light carry marks it has. 90% condition- $335 $300
Paypal pls add 3%
USA only unless previously discussed
I reserve the right to sell to whomever i wish.
Shipped USPS
Thanks for looking!
One of the screws on the frame is marred. I have two, that's the only reason i'm puttin this one up. Comes with soft CKt case. 97% condition- $425 $375
2. Boker Rexford Vallotton conversion D/A- vg-10 blade, anodized ti frame. Scale release is LSCF and the leaf spring has been jeweled. The blade edge has been modded to be used as an auto. Also sharpened and had any rough spots smoothed out. This was done by Vallottons shop. So there are some handling marks over and above the light carry marks it has. 90% condition- $335 $300
Paypal pls add 3%
USA only unless previously discussed
I reserve the right to sell to whomever i wish.
Shipped USPS
Thanks for looking!
Last edited: